Is SATA port important / slave possible?

Forum for discussions about UHD-capable dives
Post Reply
ubuntuuser
Posts: 29
Joined: Sat May 18, 2019 9:44 pm

Is SATA port important / slave possible?

Post by ubuntuuser »

I have the system-disk at the 1st Master SATA port, can I put the bd-burner at 2nd slave or must the burner be connected to the 2nd master for flashing?
MartyMcNuts
Posts: 2460
Joined: Wed Nov 22, 2017 11:45 pm

Re: Is SATA port important / slave possible?

Post by MartyMcNuts »

ubuntuuser wrote:
Wed Nov 04, 2020 2:20 pm
I have the system-disk at the 1st Master SATA port, can I put the bd-burner at 2nd slave or must the burner be connected to the 2nd master for flashing?
The sata port connection requirement is no longer valid for the current flashing methods.
Cheers :D
----------------------------------------------------------------------------------------------------------------------------
For UHD enabled drives (AU/NZ/SG) & DIY Single Drive Flasher (WW): https://www.uhdenableddrives.com
ubuntuuser
Posts: 29
Joined: Sat May 18, 2019 9:44 pm

Re: Is SATA port important / slave possible?

Post by ubuntuuser »

Thanks for explaining this!
Post Reply